3.
The wire is jammed
Try first of all to take hold of the wire at the back of the machine and push it forwards.
•
If the wire emerges switch the machine back on.
Press control switch to carry out a short cut, then resume tying operations.
(1)
•
If the wire does not emerge, pull it right out of the machine.
To do this: unclip lever.
Thread the wire through until it emerges.
Switch the machine back on and press
control switch to carry out a short cut.
(1)
Remove the wire; it may be jammed
because of a bend, in which case you will
need to pull firmly to remove it.
Then
straighten
wire so that it threads
smoothly.
Unclip lever and resume tying operations.
(2)
(2)
the
21