Table of Contents
Advertisement
Removing the reel
•
Reel with remaining wire
Clip lever upwards to allow the wire free
movement through the passage.
•
Empty reel
Pull directly on the reel to unclip it from
the machine.
Carry out a visual check on wire exit to ensure that there is no wire remaining in the machine.
After the last tying operation it is possible that some wire may remain stuck in the tying head:
•
If it does not prevent you from loading another reel,
carry on working. It will come out during tying, usually
without a problem.
•
If it does prevent you from feeding a new wire through,
disconnect the head and remove the remaining wire
by hand (see chapter "Operating problems" P 17).
10
Pull the reel to unclip it from the machine.
Advertisement
Table of Contents
