HP Vectra XA6 User Manual page 31

naja-2.fb4 Page 21 Wednesday, May 15, 1996 1:56 PM
After Installing an IDE
Device
Up to three IDE devices can be connected to the system board using
these data cables.(Refer to the storage device's manual to check
whether you need to set jumpers, or if there are any special installation
procedures.)
Examples of multiple IDE drive combinations
Configuration
1 Hard disk drive 1. Bootable hard disk drive:
2 Hard disk drives 1. Bootable hard disk drive:
2. Second hard disk drive:
3 Hard disk drives 1. Bootable hard disk drive:
2. Second hard disk drive:
3. Third hard disk drive:
1 Hard disk drive 1. Bootable hard disk drive:
1 CD-ROM 2. CD-ROM:
2 Hard disk drives 1. Bootable hard disk drive:
1 CD-ROM 2. Second hard disk drive:
3. CD-ROM:
IDE drives are automatically detected by the Setup program. However,
a newly installed CD-ROM may require that you install an appropriate
device driver. Refer to your operating system documentation for details.
For information on how to obtain the latest available drivers from HP,
refer to "HP BBS Library", on page 63.
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
Connections to data cables
First connector, Primary IDE Cable
First connector, Primary IDE Cable
Second connector, Primary IDE Cable
First connector, Primary IDE Cable
Second connector, Primary IDE Cable
Secondary IDE Cable
Master connector, HDD data cable
Secondary IDE Cable
First connector, Primary IDE Cable
Second connector, Primary IDE Cable
Secondary IDE Cable
English 21