Connecting Audio Accessories - HP Vectra XA6 User Manual

Hp vectra xa6: users guide
Hide thumbs Also See for Vectra XA6:
Table of Contents

Advertisement

naja-1.fb4 Page 5 Wednesday, May 15, 1996 1:54 PM
WARNING

Connecting Audio Accessories

If your PC comes with an audio board already installed, the PC has a
Headphones jack and a Microphone jack on the rear panel. An audio
Stereo In jack, an audio Stereo Out jack, and a MIDI interface
connector are also located on the rear panel.
NOTE
The internal speaker and the Stereo Out jack on the rear of your PC are
deactivated when you use the Headphones jack.
The internal speaker is deactivated when you use the Stereo Out jack.
To avoid discomfort from unexpected noise, always turn the volume
down before connecting headphones or speakers.
Listening to loud sounds for prolonged periods may permanently
damage your hearing. Before putting on headphones, place them
around your neck and turn the volume down. When you put on the
headphones, slowly increase the volume until you find a comfortable
listening level, and leave the volume control in that position.
1 Setting Up and Using Your PC
Connecting Audio Accessories
The audio accessories shown
here (headphones, microphone,
speakers, and hifi system) are not
supplied with your PC
English
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vectra xa 6/xxx

Table of Contents