HP Vectra VL800 Technical Reference Manual page 28

2 VL800 Minitower
Overview
Feature
Firmware - BIOS
Operating System
Main Memory
Mass Storage
Optional SCSI Controller
IDE Controller
Graphics Controllers
Accessory Card Slots
28
Flash EEPROM: Intel's Firmware hub concept
Most models are preloaded with Windows 2000. Some models are preloaded
with Windows NT® 4.0.
2 pairs of RIMM sockets supporting 2 or 4 PC800 RDRAM memory modules.
Each pair of memory sockets must contain identical memory modules
(identical in size, speed and type). That is, sockets A1 and B1 must contain
identical modules, and sockets A A A A 2 2 2 2 and B B B B 2 2 2 2 must contain identical modules (or
continuity modules).
If only two RDRAM modules are installed, use the sockets marked A A A A 1 1 1 1 and
B B B B 1 1 1 1 . The other two sockets (A A A A 2 2 2 2 and B B B B 2 2 2 2 ) must contain continuity modules
Models are supplied with non-ECC RDRAM modules.
Both ECC and non-ECC modules are available.
Up-to-date memory upgrades are listed on the HP PC Accessories website at:
www.hp.com/go/pcaccessories
Five mass storage shelves supporting:
One front-access, third-height, floppy disk drive
•
Three front-access, half-height, 5.25-inch drives
•
Two internal 3.5-inch hard disk drives (one full-height, one half-height).
•
LSI Logic Ultra 160 SCSI PCI card
All models include an integrated Ultra ATA-100 controller that supports up to
four IDE devices
nVidia GeForce2 GTS AGP graphics controller with 32 MB graphics memory
•
Matrox Millennium G450-Dual monitor AGP graphics controller with 16 MB
•
SGRAM graphics memory.
One AGP (Accelerated Graphics Port) 4x 32-bit slot supporting standard 1.5V
AGP cards ( 25 W) only.
Hardware protection prevents any 3.3V AGP cards from being used.
Five 32-bit 33 MHz PCI (Peripheral Component Interconnect) slots supporting
all bridges and multi-function PCI devices. All five PCI slots comply with the
PCI Specification 2.2.
PCI slot 5 contains a LAN interface board.
Description