Clearing The Cmos - HP Vectra VL800 Technical Reference Manual

6 HP BIOS

Clearing the CMOS

Clearing the CMOS
1 Turn off the PC, disconnect the power cord and all cables, then remove
the cover.
2 Set the system board switch
3 Replace the cover, and reconnect the power cord and video cable.
4 Reboot the PC. A message similar to the following will be
displayed:
"Configuration has been cleared, set switch Clear to the ON position
before rebooting."
5 Turn off the PC, disconnect the power cord and video cable, and remove
the cover.
6 Set the system board switch
7 Replace the cover, and reconnect the power cord and data cables.
8 Switch on the PC. Run the Setup program by pressing
the CMOS default values will be automatically downloaded and saved.
9 Press to save the configuration and exit from the Setup program.
Esc
116
8 to the ON position.
8 to the OFF position.
. Then press ,
F2 F9