Intel Nic (Network Interconnect) Lan Card - HP Vectra VL800 Technical Reference Manual

4 Interface Cards
Network Cards

INTEL NIC (Network Interconnect) LAN Card

INTEL NIC LAN Card Features
Feature
IEEE802.3 100 Base-TX
Interface IEEE802.3 10 Base-T
32-bit 10/100 BT full duplex RJ LAN Port
Two LEDs:
LED
•
•
PCI 2.2 Specification, PC 99.
Labels
Power Management •
•
•
•
•
•
DMI 2.0 and DMI 2.0 SNMP mapper
Manageability
Diagnostic •
•
•
Major OSes, Minor OSes
Drivers
Onboard flash ROM
Boot ROM
This feature enables a host computer to remotely (over the network) power
Remote Wake Up
on computers and wake computers up from energy-saving Sleep mode. For
(RWU)
these features to work, use the Setup program to configure the BIOS.
INTEL NIC LAN Card LED Descriptions
LED On
Adapter and hub are
ACT/LNK
receiving power. Cable
connection is good.
Operating at 100 Mbps
100 TX
86
Description
one for act/lnk (activity and link)
one for 10 MB operation (on = 100 MB, off = 10MB).
Wfm 2.0 compliant
RPO and RWU for APM Windows 95 and Windows 98
OnNow 1.0, APM 1.2
PCI power management 1.1
VccAux s3.3 V support via PCI bus 2.2
VccAux 5 V support via 3-pin WOL.
Windows and DOS based
Mac address DOS report tool
User Diag for DOS, Windows NT 4, Windows 95 and Windows 98.
Flashing
Receiving or sending
packets
N/A
Off
Adapter and hub are not
receiving power. Cable
connection could be faulty
or there is a driver
configuration problem.
Operating at 10 Mbps