Installing Removable Media - HP Vectra VL800 User Manual

WARNING

Installing Removable Media

To avoid electric shock and harm to your eyes by laser light, do not open
the laser module. The laser module should be serviced by service personnel
only. Do not attempt to make any adjustment to the laser unit. Refer to the
label on the CD-ROM drive for power requirements and wavelength. This
product is a class 1 laser product.
The PC has an integrated Enhanced IDE controller which supports up to
four IDE devices. Removable media IDE devices, such as CD-ROM drives,
DVD drives, tape drives and Zip drives require front access. You can install
a removable media IDE drive in an empty front shelf.
Refer to the drive's manual to see if you must set jumpers or if there is a
special installation procedure to follow.
1 Remove the computer's cover and front panel (refer to page 25 for
instructions).
2 Press the two latches inward and slide out the drive tray in which you
want to install a new device.
3 Remove the tray's metal RFI shield.
2 Installing and Replacing Hardware Parts in Your PC
Installing Removable Media
41