NDIS 2.01 Driver for Artisoft LANtastic 6.0
Artisoft LANtastic 6.0 uses the NDIS 2.01 specification. To install the NDIS 2.01
driver in LANtastic versions earlier than 6.0, please contact your Artisoft
representative. The NDIS 2.01 driver itself is provided in the
Installation Procedure
To install a driver for LANtastic 6.0, start from the DOS system prompt. Follow the
steps listed below:
1 Insert Disk 1 of LANtastic 6.0 into your flexible disk drive (for example, A). At the
DOS prompt type:
A:\install
This starts the LANtastic installation process.
2 Artisoft's installation program will then search for Microsoft Windows on your
system. If Windows is not found, press
program under DOS and go to the steps given under
page 60.
Otherwise, if Windows is found, Windows will be started. Go to the steps
given under
See "Installation for Windows" on page 61.
4 Installing Other Network Drivers
NDIS 2.01 Driver for Artisoft LANtastic 6.0
directory.
NDIS\DOS
at the message to run the install
See "Installation for DOS" on
English
59