Adjusting The Height Of The Integral Seat Belts; Use For Children From 100 To 150 Cm; Turning The Safety Seat Into A Booster Seat With Backrest - JANE GROOWY iSIZE Manual

IN THE SAFETY SEAT (FROM 60 TO 105 CM)
• Fit the cushion insert (15) if necessary (from 60 to 75 cm).
• Loosen the integral seat belts by pulling the straps (5) above the buckle while
pressing the strap tightening button (5b).
• Unfasten the buckle (5a). 2 .i
• Place the child in the seat making sure that he is sitting as far back as
possible and with his back upright. Bring the upper ends of the buckle
together. 2 .k
• Insert them into the fastener and press until you hear them click locked.
2
.l
• Pull the tightening strap (5b). The correct strap tension is very important
for the child's safety, do not leave the straps too loose.
I_ADJUSTING THE HEIGHT OF THE INTEGRAL
SEAT BELTS
The height of the shoulder straps should be adjusted as the child
grows. While the child is sitting in the seat, check that the shoulder
straps are in the right position. They should be slightly above the child's
shoulders. GROOWY, in this configuration, has 4 seat belt positions, as
the strap height is adjusted the headrest will move.
To adjust the height follow the steps below:
• Pull the lever found on the back of the headrest (4), this will unlock the
headrest position.
• Move the headrest (3) to the right position for the child and release the
lever. Move the headrest until you hear it click as it locks into place. Pull
2
.j
2
.h
2
.m
the headrest to make sure that it is securely locked in place.
!
IMPORTANT: Adjust this height as the child grows
Removing the seat when it is installed with ISOFIX:
• Release the ISOFIX anchors by pulling both release straps (7). The signals
on the front of the base (8) will turn red.
• Remove the seat. Press the ISOFIX anchors (6) to store them inside the
base.
USE FOR CHILDREN FROM 100 TO 150 CM WITH VEHICLE SEAT
BELT
J_TURNING THE SAFETY SEAT INTO A BOOS-
TER SEAT WITH BACKREST
• To turn the GROOWY safety seat into a booster seat with backrest you
need to rotate the seat 180 degrees on the base. To do this step you need
to uninstall the seat.
• Pull the straps (7) to release the ISOFIX anchor. (9)
• On the bottom of the base there is a red lever that unlocks the seat rotation
system. Press it and turn the seat to the next locking position.
• Adjust the length of the leg to the shortest position, to do this release the
locking system of the leg by sliding the button (9a) to the right.
• Insert the leg into the slot in the base. There is a lock to hold it in place.
3
.d
3
.a
3
.b
3 .c
29
EN