HP Vectra VEC 7 Hardware Manual page 13

4 Insert the new drive into the spare shelf in the drive tray and secure
the new drive to the tray using the screws provided with the drive.
5 Carefully put the drive tray back into the PC, and secure it
in position using the two retaining screws that you
removed earlier.
Carefully put the drive tray back into the PC, and secure
it in position using the retaining bracket.
6 Connect the power cable and the data cable to the rear of the new
hard disk drive. Remember to replace those for the floppy disk drive
and the existing hard disk drive also.
Vectra VE 7 (Celeron Processor) — Replacing Hardware Components
Installing an IDE Hard Disk Drive in an Internal Shelf
Screws go here
(and the same on
the other side)
English 13