HP Vectra VE5 4 User Manual page 47

8 Lower the drive into the free groove of the mounting bracket (ensure
that the top of the drive is facing the right way). Use the two pins on
the mounting bracket to slot the drive into place.
9 Position the other mounting bracket on top, aligning it properly so
that it clicks into place.
10 Draw the computer's data cable through the front drive bay area and
connect the data cable to the rear of each drive.
The connectors are shaped to fit one way only. If you are not sure
which connector to use, refer to "Connecting IDE Devices", on page
27.
Data cable
11 Using both hands, lift the drive unit and slide it back into the
computer about halfway.
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
English 37