Utilities - Edimax IC-7010 Series Manual

2.6.4 Utilities

This menu allows you to upgrade firmware, clear all settings, reboot the IP
camera, and switch LED lights on/off.
The descriptions of every setting in this menu will be given below:
Item
Upgrade
Firmware
Reset to Factory
Defaults
Description
If you downloaded latest firmware file from our website,
you can click ‟Browse‟ button to pick a firmware file
located on your computer‟s hard drive and you can
upload the firmware file to the IP camera later.
After you selected a proper firmware file from your
computer, click „Upgrade Firmware‟ button to start
upgrade. DO NOT DISCONNECT NOW!
If the firmware file you provided is invalid of you didn‟t
provide the firmware file, you‟ll be prompted to select
another valid firmware file again.
The IP camera will reboot after the upgrade procedure is
done. PLEASE NOTE THAT THE IP ADDRESS OF THE
CAMERA WILL RESET TO DEFAULT VALUE:
192.168.2.3
Clear all settings in the camera. Please think again
before you do this, and then click this button to reset all
settings.
NOTE: IP address will be reset to default value
'192.168.2.3' also. You'll need to change the IP address
79