Qilive Q.6252 User Manual page 15

Note: Given the limit values of the ambient temperature range for the climate classes for
which the refrigerating appliance is designed and the fact that the internal temperatures
could be affected by such factors as location of the refrigerating appliance, ambient
temperature and the frequency of door opening, the setting of any temperature control
device might have to be varied to allow for these factors, if appropriate.
4.6 Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not
observed.
5. USE
The combination of drawers, baskets and shelves that result in the most
efficient use of energy for the refrigerating appliance;.
The recommended setting of temperatures in each compartment for optimum
food preservation. These settings shall not contradict the storage conditions
set out in Annex III, Table 3;
5.1 First use
• Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately.
Make sure to energize the refrigerator after more than 1 hour of standing, so as to ensure
its normal operation.
• Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
• Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer
door, if the temperature inside the freezer compartment drops obviously, it indicates the
refrigeration system is working normally.
• Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator
will be automatically controlled according to the user's temperature setting. After the
refrigerator is fully cooled, put in foods, which usually need 2~3 hours to be fully cooled.
In summer, when the temperature is high, it takes more than 4 hours for the foods to
be fully cooled (Try to open the refrigerator door as less as possible before the internal
temperature cools down).
15
EN