Quick Instructions; Hardware Connection - ZLG CANFDWIFI-100U User Manual

CANFDWIFI-100U
Single-channel CAN (FD) to WIFI converter

5. Quick Instructions

This chapter describes the basic usage of CANFDWIFI-100U and the installation
settings of related software and hardware. You will quickly grasp how to use the product,
and have an intuitive understanding of the communication between the network and CAN
devices.
Before using the CANFDWIFI-100U device, learn about the network parameters such
as the IP address of the device. The CANFDWIFI-100U device supports two IP acquisition
methods: "static acquisition" and "dynamic acquisition". "Static acquisition" indicates that
the device uses the "IP address", "subnet mask" and "gateway" specified by the user;
"Dynamic acquisition" indicates that the device obtains the IP address, subnet mask, and
gateway information from the DHCP server on the network over DHCP.

5.1 Hardware Connection

Connect the device to a 9-48 V DC power supply, and use a crossover cable to
connect the LAN port of the device to the network port of the PC. Or, when the wireless
WLAN of CANWIFI-100U is running in AP mode and the LAN port is not connected, the
device "CANFDWIFI100U" can be searched through the wireless network card of the PC,
as shown in Figure 5.1. The wireless network card of the PC is set to obtain the IP
address automatically, and you can connect by entering the wireless password of
"12345678".
Figure 5.1 Finding CANFDWIFI100U in wireless manner
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
11
User Manual