Table of Contents
Advertisement
CANFDWIFI-100U
Single-channel CAN (FD) to WIFI converter
When the device configuration is completed, the device works in the specific mode.
The following describes how to use the working modes.
5.6.1 TCP Server Mode
In TCP Server mode, the device will not actively connect with other devices. It always
waits for the connection of the client (TCP Client), and can carry out two-way data
communication after establishing a TCP connection with the client.
When the device acts as a TCP server, the PC should act as a TCP client. Open the
[Device Management] interface of ZCANPRO, select CANFDWIFI-TCP as the device type,
open the device, and start the device.
On the startup device interface (as shown in Figure 5.28), select [Client] as [Working
Mode], and enter [IP Address] and [Working Port]. If the current device IP address is
"192.168.0.178" and the port is 4001, set this parameter.
[Protocol] is determined by the [controller type] of CAN configuration. If it is
configured as a CAN controller, select CAN; if it is configured as ISO/Non-ISO CANFD,
select CANFD.
[CANFD acceleration] is determined by the user. When [No] is selected, all CANFD
messages sent are not accelerated; otherwise, they are all accelerated.
Click [OK].ZCANPRO will connect to the device.
Figure 5.27 Different working modes
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
28
User Manual
Advertisement
Table of Contents
