Table of Contents
Advertisement
CANFDWIFI-100U
Single-channel CAN (FD) to WIFI converter
5.2 Software Installation
Before using the device, install the supporting software ZCANPRO. The software can
be downloaded from the official website of ZLG Electronics http://www.zlg.cn.
5.3 Configuring the Device
When the device IP address is forgotten or the device uses DHCP to obtain the IP
address automatically, the current IP address of the device can be obtained by using the
network device configuration tool software.
Before using the device, configure the device IP address, CAN port baud rate and
other parameters. Configure the device by using the network device configuration tool in
ZCANPRO. The procedure is as follows:
5.3.1 Running the Configuration Tool
Run the ZCANPRO software, click [Tools] in the upper part of the software, and select
[Network Device Configuration Tool], as shown in the red circle in Figure 5.2. Figure 5.3
shows the configuration software interface.
Figure 5.2 Running the network device configuration tool
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
12
User Manual
Advertisement
Table of Contents
