Table of Contents
Advertisement
CANFDNET-200U
High-Performance Dual-Channel Ethernet to CAN (FD) Converter User Manual
5. Quick Guide
This chapter introduces the basic usage of CANFDNET-200U. You will quickly master its use and have an
intuitive understanding of data forwarding between Ethernet and CAN (FD).
CANFDNET-200U supports three work modes, which can work at the same time. This chapter introduces
each work mode.
5.1 Hardware Connection
Connect the device to a 9-48 V DC power supply, and use a crossover cable to connect the LAN port of the
device to the network port of the PC.
5.2 Software Installation
Before using the device, install the ZCANPRO (V2.0.39 or above), which can be downloaded from the official
website.
5.3 Device Configuration
Before using the device, configure the device IP address, CAN port baud rate and other parameters.
Configure the device by using the network device configuration tool in ZCANPRO. The procedure is as follows:
5.3.1 Running the Configuration Tool
Open the ZCANPRO software, click [Tools] in the upper part of the software, and select [Network Device
Configuration Tool], as shown in the red circle in Figure 5.1. Figure 5.2 shows the configuration software interface.
Figure 5.1 Running the network device configuration tool
©2021 Guangzhou ZLG Electronics Co., Ltd.
10
User Manual
Advertisement
Table of Contents
