Airflow Sensor + Grid 120 * 120 * 10Mm Nc - NetPing IO R401 User Manual

Coloured cable
Coloured
A logic level on the line in the "output" mode used for power supply will control the operation of the buzzer. When
log. 1 - the beacon is active, at log. 0 - the beacon is off.
The sensor is supplied with a non-detachable cable with a lug at the ends. You can extend the length of the cable
using Cable 4 extenders,
cross section of at least 0.4 mm

Airflow sensor + GRID 120 * 120 * 10mm NC

This sensor is a "dry contact" type sensor, so the order of connecting wires does not matter. The number of
connected sensors is restricted only by the number of free IO1...2 and I3...4 lines.
Cables
The first wire
4m, which are connected in series into each other, or independently using any wire with a
2
. The maximum permissible loop length is 100 meters.
[ENG] NetPing IO R401, User Guide -[ENG] [R401] 5. Connection of sensors
Terminal
One of the lines IO1...2 or I3...4
GND
Terminal
[ENG] [R401] 5. Connection of sensors
–