External Netping Ac/Din Socket; Buzzer (Mod.std-3025) - NetPing IO R401 User Manual

Cable (coloured)
Green
White
Black
Red
Attention! The sensors of the "dry contact" type: a supply volyage sensor 995S2, a liquid sensor and other are
connected to IO1...2 lines of the device or to input lines. You can conect any 4 sensors from this set.
Attention! The corresponding IO-line must be switched to the "input" mode in the device settings.
The sensor is supplied with a non-detachable cable with a lug at the ends. You can extend the length of the cable
using Cable 4 extenders,
cross section of at least 0.4 mm
External NetPing AC/DIN socket
The number of connected NetPing AC/DIN sockets
When you connect the socket, you will use all the wires, except the brown (white) one. The IO-line to which the
NetPing AC/DIN socket is connected should be put into the "Input" state. When the state is "log. 0 "on the IO-line at
the socket there will be 220 V - the load will be turned on. When the state is "log. 1 "on the IO-line, the socket will be
withour power, the load will be disconnected.
Attention! The brown (white) wire is not used and should be left disconnected.
The management of external sockets from IO-lines:
Coloured cable
Blue (green)

Buzzer (mod.STD-3025)

Coloured cable
While
Marked (red) wire
The first wire after the marked one
The second wire after the marked one
The third wire after the marked one
4m, which are connected in series into each other, or independently using any wire with a
2
. The maximum permissible loop length is 100 meters.
Red
Black
[ENG] NetPing IO R401, User Guide -[ENG] [R401] 5. Connection of sensors
Cable (flat)
is restricted only by the number of free IO-lines.
+5V
GND
One of the IO1...2 lines
Terminal
One of the IO1...2 lines (in the «output» mode, log. 1)
Terminal
One of the lines IO1...2 or I3...4
GND
GND
+12 V
Terminal
[ENG] [R401] 5. Connection of sensors
–