NetPing IO R401 User Manual page 17

[ENG] NetPing IO R401, User Guide -[ENG] [R401] 5. Connection of sensors
Cables Terminal
The second wire GND
Depending on the input (IO1 ... 2 or I3 ... 4) which the sensor is connected to on the terminal block, it is displayed on
that channel IO1 ... 2 or I3 ... 4 in the device web interface.
Attention! The corresponding IO-line must be switched to the "input" mode in the device settings.
The sensor is supplied with a non-detachable cable with a lug at the ends. You can extend the length of the cable
using Cable 4 extenders, 4m, which are connected in series into each other, or independently using any wire with a
2
cross section of at least 0.4 mm . The maximum permissible loop length is 100 meters.
[ENG] [R401] 5. Connection of sensors
–