[Eng][R401] 7. Resetting Settings To Default Values - NetPing IO R401 User Manual

[ENG][R401] 7. Resetting Settings to Default Values

To reset parameters you have to do following steps:
• switch off the power;
• press and hold down Default button
• switch on the power;
• wait for 10 seconds (the CPU indicator will blink);
• release the Default button.
If you follow the steps successfully, the LED will blink, indicating the reset of the parameters
By default, the device has the following parameters:
Username: visor
Password: ping
IP-address: 192.168.0.100
The musk of the subnetwork: 255.255.255.0
Gate: не установлен
SNMPcommunity: SWITCH
MAC-address: 00 a2 xx xx xx xx
Here xx xx xx xx corresponds to the serial number of the device. Thus, all devices after production have unique
MAC addresses.
After resetting the parameters to the default values, it is necessary to carry out the initial configuration of the
device.
[ENG] NetPing IO R401, User Guide -[ENG][R401] 7. Resetting Settings to Default Values
[ENG][R401] 7. Resetting Settings to Default Values
–