Coloured cable
Black (common)
Red (Normally closed contact)
White (Normally open contact)
The sensors of the "dry contact" type: a supply volyage sensor 995S2, a liquid sensor and other are connected
to IO1...2 lines of the device or to input lines. You can conect any 4 sensors from this set.
Attention! The corresponding IO-line must be switched to the "input" mode in the device settings.
The sensor is supplied with a non-detachable cable with a lug at the ends. You can extend the length of the cable
using
Cable 4 extenders,
cross section of at least 0.4 mm
PIR detector (mod.M105-1E)
PIR detector is connected with a four-wire line in accordance with the table.
4m, which are connected in series into each other, or independently using any wire with a
2
. The maximum permissible loop length is 100 meters.
[ENG] NetPing IO R401, User Guide -[ENG] [R401] 5. Connection of sensors
One of the lines IO1...2 or I3...4
One of the lines IO1...2 or I3...4
Terminal
GND
[ENG] [R401] 5. Connection of sensors
–