[Eng] [R401] 4. Installation And Connection - NetPing IO R401 User Manual

[ENG] NetPing IO R401, User Guide -[ENG] [R401] 4. Installation and Connection

[ENG] [R401] 4. Installation and Connection

In order to connect the device follow these steps:
1. Remove the device from its packaging.
2. Connect the devices which you need (see «Connection of sensors» section).
3. Connect the power supply unit to the power connector.
4. Insert the power supply unit into an electrical socket. The power indicator will light up.
5. Insert the Ethernet-cord into any Ethernet-connector of the devicer, connect it to the switch or directly to the
network card of the computer.
6. IP address was set by default. Fot the initial setting of the device make sure that the address of your computer is
located in the same IP-subnet as the address of the device. For example, the address which is set on the computer
can be 192.168.0.11 mask 255.255.255.0.
[ENG] [R401] 4. Installation and Connection
–