Table of Contents
Advertisement
[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Plugging External Sensors
Depending on ID, a temperature sensor will be displayed on a corresponding channel in a web interface of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
be done independently with the help of any wire with a minimum cross section of 0,4 mm
length of a flat cable is 10 m from each sensor to a device (star topology).
Plugging Temperature
All 8 temperature sensors are plugged in parallel one to another.
The first wire after a labeled one
The second wire after a labeled one
The third wire after a labeled one
Important! it is prohibited to plug temperature sensors with the same identification numbers (ID) to a device.
Depending on ID, a temperature sensor will be displayed on a corresponding channel in a web interface of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help
of flat cable extenders of
be done independently with the help of any wire with a minimum cross section of 0,4 mm
length of a flat cable is 10 m from each sensor to a device (star topology).
Plugging a humidity sensor WS-2
A loop of a sensor is a flat loop with a labeled first wire (red).
Colored Loop
Yellow
Green
Red
Black
RC-4 sensor, which are sequentially plugged one into another. Otherwise, it can
Sensors TS/WT
Flat Loop
Labeled (red) wire
RC-4 sensor, which are sequentially plugged one into another. Otherwise, it can
The first wire after a labeled one
The second wire after a labeled one
The third wire after a labeled one
Flat Loop
Labeled (red) wire
2
. Maximum allowable
Contact Name
SC
SD
+
G
2
. Maximum allowable
Contact Name
[ENG] [2PWR,v2SMS] Plugging External Sensors
SC
SD
+
G
–
Advertisement
Table of Contents
