Table of Contents
Advertisement
[ENG] [IOv2] Plugging Sensors
It is prohibited to plug sensors and external modules into NetPing devices when a power supply is on!
Plugging
a Door Sensor
A sensor is a «reed contact», therefore the order of connecting wires does not matter.
Loop
First wire
Second wire
A sensor will be displayed in a device interface as a status of an IO line, to which it is connected.
Important! A corresponding IO line must be switched to an "input" mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
flat cable extenders of RC-4
independently with the help of any wire with a minimum cross section of 0,4 mm
flat cable is 100 m.
Plugging Shock Sensor PI-90d
A shock sensor is connected by a four-wire line according to the table below:
Blue (an output of a zone of light shocks and vibration)
Green (an output of a zone of hard shocks)
Red
Black
On a body of a sensor body, there are LED indicators, sensitivity adjustment screw and a socket for plugging wires. A
corresponding zone will be displayed in a device interface as a status of an IO line, to which it is connected. To
adjust a sensitivity of a sensor, a sensitivity adjustment screw is used. Turning a screw clockwise leads to increasing
of a sensitivity, while turning it counterclockwise leads to decreasing of a sensitivity. When a sensor registers a
shock, a status of a line of a light shock zone and a hard shock zone is switched to a low level for short time only,
therefore there is a need to use a mechanism of sending SNMP TRAP notifications by a
Important! Corresponding IO lines must be set to an "input" mode in settings of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
flat cable extenders of RC-4
NetPing IO v2 Terminal
One of IO lines – 1 - 4
GND
sensor, which are sequentially plugged one into another. Or it can be done
Loop Color
sensor, which are sequentially plugged one into another. Or it can be done
[ENG] NetPing IO v2, User guide -[ENG] [IOv2] Plugging Sensors
2
. Maximum allowable length of a
Contact Name
One of IO lines – 1 - 8
One of IO lines – 1 - 8
+U
GND
NetPing IO
v2 device.
[ENG] [IOv2] Plugging Sensors
–
Advertisement
Table of Contents
