ElectrIQ IQOOL-SMART15HP User Manual page 4

• The unit must be installed on a solid vertical wall by a competent person. The electricity
supply must only be connected after installation is complete.
• R290 refrigerant gas complies with European environmental directives.
• R290 has a low GWP (Global Warming Potential) of 3.
• These air conditioners contains about 290 g of R290 refrigerant gas.
• Do not install or store in an unventilated space with an area smaller than 15m
The room must be such as to prevent stagnation of possible leaks of refrigerant gas as
there could be a danger of fire or explosion hazard should the refrigerant come into
contact with electric heaters, stoves or other sources of ignition.
• If the appliance is installed, used or stored in an unventilated room, the room must be
such as to prevent stagnation of possible leaks of refrigerant gas as there could be a
danger of fire or explosion should the refrigerant come into contact with electric heaters,
stoves or other sources of ignition.
• Refrigerant gas may be odourless.
• Do not use the product and contact the retailer for advice, if damage has occurred to the
unit which may have compromised the refrigerant system.
• Any repairs or maintenance must only be carried out on the unit by a suitably qualified
engineer. Before opening and servicing the unit the authorized engineer must be in
possession of a copy of the manufacturer's service manual and must follow the safety
information contained within it to ensure all hazards are minimized.
• The refrigerant system should not be perforated or punctured.
Energy Saving and Unit Safety Protection Tips
• Do not cover or restrict the airflow from the outlet or inlet grills.
• Keep the filters clean. Under normal conditions, filters should only need cleaning once
every three weeks (approximately). Since the filters remove airborne particles, more
frequent cleaning maybe necessary, depending on the air quality.
• For the initial start-up set the fan speed to maximum and the thermostat to 4-5 degrees
lower than the current temperature. After, set the fan switch to low and set the
thermostat to your desired setting.
• To protect the unit, we recommend not using the cool mode when the ambient
temperature is higher than 35
NOTE: Some pictures and information may vary from the final product. This is due to
continual product improvement
o
C.
.
3
2
per unit.