Table of Contents
Advertisement
10.10.9 Hardware
Installation
PMM 9030 is delivered from factory ready to use as a companion of the
PMM 9010.
Remove the receiver from its cardboard and install it where desired, e.g.
directly on the antenna output connector (see detailed instruction later on in
this manual), or anyway connect the output of your antenna or transducer
device to the N connector on the front panel of PMM 9030 and immediately
start to measure up to 3 GHz.
Remove the Optic Link protective cover pressing the small tab under the
protective cover and gently pull it; keep it aside for future protection of the
port on the receiver. Repeat the same operations for the Optical Link #1 on
the PMM 9010.
Connect the Optic Fiber delivered with PMM 9030 to the PMM 9030 and to
the PMM 9010 pushing the connector in the Optical port until a "click" can be
heard; be sure the key of the connector is in the right orientation.
Once fiber optic cable has been connected properly on both sides it's
possible to start in operating PMM 9030 together with PMM 9010.
Fig. 10-3 PMM 9030 Fiber Optic Link to PMM 9010
Switch ON the PMM 9030 keeping the "ON" small red button pressed until
the PW Led lights up blinking in Red colour (about 1 second), then release
the button. To avoid unwanted starts, if the "ON" button is kept pressed for
a too short time or for more then 2 seconds the instrument is switched
automatically off.
Push and keep pressed the "ON/OFF" button for more then 2 seconds to
switch off the receiver.
After having been switched ON, the PMM 9030 boots with its internal BIOS
and in matter of few tens of second runs the firmware which manages the
receiver.
Now switch ON the 9010: a screen like the following should appear.
PMM 9030 Frequency Extension
10-11
Advertisement
Table of Contents
