Table of Contents
Advertisement
8.5 To transfer data
To finally perform the Firmware Update, switch OFF the PMM 9010 at first,
run the "9010 Update" to make the related window appearing with the
"Waiting for BIOS" writing at the bottom, then switch ON the PMM 9010 and
the FW download will begin automatically.
During the firmware storing procedure, a blue bar will progress from left to
right in the window of the PC, showing percentage of downloading time by
time until 100%. In the meanwhile on the 9010 display the BIOS page
appears, showing again the updating status.
When FW download finishes, following message appears to show that
everything was properly completed:
In case of failure, an error message is showed instead.
After Firmware Update is successfully completed, switch OFF and then ON
again the PMM 9010, looking at screen.
Now at the top of the display a different FW Release Number and Date is
showed after "9010-BIOS-...", as per the following:
In case the release should not comply with what expected, just check about
the FW file used during installation or get in contact with the nearest
NARDA Local Distributor.
It is now possible to disconnect the cable connected to the PC, with the
PMM 9010 receiver either switched On or Off.
To obtain up-to-date Firmware or PC Utility for PMM 9010, the user
can contact his NARDA agent or download it directly from Support
area of EMC Product Range on the following Web Site: www.narda-
sts.it.
Updating Firmware
8-3
Advertisement
Table of Contents
