Table of Contents
Advertisement
8.1 Introduction
8.2 System requirements The minimum requirements to allow the software to operate properly are
8.3 Preparing the
Hardware
Document 9010EN-70106-1.59 - © NARDA 2007
8 - Updating firmware
The PMM 9010 features a simple and user-friendly method for updating its
internal firmware through a Personal Computer (PC). This section provides
all the information required for easy updating.
the following:
• 486 Processor or Pentium
• 16 Mb of RAM
• at least 10 Mb of free space on hard disk
• 1 free Serial Port (RS-232), or, alternatively, a USB/RS-232 Adapter
with related driver
• Windows Operating System 95/98/2000/XP
Connect the RS-232 cable supplied with PMM 9010 directly or through a
USB/RS-232 Adapter separately purchased (once related driver has been
properly installed), to the 9 pin socket situated on the back panel of PMM
9010 on one side and to a free RS232 port (or USB in case of Adapter's
use) on the PC side.
The first free RS-232 port will be automatically detected by the Firmware
Update Program during installation. In case of troubles please check port
assignments on the PC through the Control Panel utility.
Updating Firmware
8-1
Advertisement
Table of Contents
