Table of Contents
Advertisement
10.10.1 Introduction
10.10.2 Initial Inspection
10.10.2.1 Packing and
Unpacking
10.10.3 Preparation for
Use
10.10.4 Battery charger
-
+
10.10.4.1 To replace the
mains
connector of the
battery charger
10.10.4.2 To charge the
internal battery
10-8
PMM 9030 Frequency Extension
10.10 - Installation
This section provides the information needed to install your PMM 9030.
It includes the information pertinent to initial inspection and power
requirements, connections, operating environment, instrument mounting,
cleaning, storage and shipment.
When receiving the equipment, first inspect the shipping cardbox for any
damages.
If the shipping box is damaged, it should be kept until the contents of the
shipment have been checked for completeness and the instrument has
been checked mechanically and electrically.
Verify the availability of all the shipped items with reference to the shipping
check list enclosed with the Operating Manual.
Notify any damage to the forwarder personnel as well as to your NARDA
Representative.
To avoid further damage, do not turn on the instrument when there
are signs of shipping damage to any portion of it.
This is a Safety Class III apparatus, but it is also equipped with a
protective/functional earth terminal on the rear panel. A good
safety/functional ground connection should be provided before to
operate the receiver.
The battery charger supplied with the receiver can work at either 50 Hz or
60 Hz with a supply voltage rated between 100 and 240 Volt.
It is supplied with different connectors to fit all the possible outlets in
accordance with the various National standards.
Battery charger: DC, 10 - 15 V, ~ 2500 mA
=> DC Connector
To replace the mains connector, simply remove the one installed on the
battery charger sliding it off, and insert the one that fits the outlets in use.
In order to guarantee the best autonomy of the internal battery, we
recommend to fully recharge it before using the receiver.
To charge the battery, simply connect the battery charger to the mains
power socket and then insert the DC output connector of the battery
charger to the input CHARGER on the rear panel of the receiver.
ALWAYS connect the battery charger to the mains power BEFORE
connecting the DC output to PMM 9030. The battery charger has an
internal protective circuit that will not let it work if there is a load
connected to the output connector before the connection to the
mains is done.
Advertisement
Table of Contents
