D I R E C T I O N S F O R U S - Kenwood CS-5140 Instruction Manual

READOUT DISPLAY
CD POSITIONS OF T H E DISPLAY
Displays the calendar, scale factors, cursor
m e a s u r e m e n t d a t a ,
positions on the C R T .
12) DISPLAY CONTENTS
1 Calendar/Clock
Displays a calendar and clock in the following order:
Month-Day-Year-O'clock-Minute
Month: J A N , F E B , M A R , A P R , M A Y , J U N , J U L ,
A U G , S E P , O C T , NOV, D E C
Day: 0 1 to 3 1
Year: 0 0 to 9 9
O'clock: 0 0 to 2 3
Minute: 0 0 to 5 9
These setting can be changed with the switch located
on the bottom. (For resetting, refer to the Maintenance
section.)
2 Cursor Mode
The current setting cursor mode, which depends on the
combination of the operation controls, is displayed.
AV2, AT, MAT, RATIO, PHASE
3 Cursor Measuring Data
The result measured by the t w o cursors is displayed. In
the 1 M T mode, when the t w o
each other and the measurement nears its limit, a " ? "
will be displayed in front of the measured data. This
s h o w s that the measured data is not available.
DIRECTIONS FOR USE
e t c . a t t h e f o l l o w i n g
cursors approach
Fig. 5
4 CH1 Scale Factor
Displays the C H 1 vertical axis sensitivity to one divi-
sion. When not in C A L mode, a " > " is displayed after
C H 1 .
NOTE: T h i s is not displayed when the MODE control
(Q)
is set to C H 2 .
5 CH2 Scale Factor
Displays the C H 2 vertical axis sensitivity to one divi-
sion. When not in C A L mode, a " > " is displayed after
C H 2 .
NOTE: T h i s is not displayed when the MODE control
© i s set to C H 1 .
6 ADD
" + " is displayed w h e n the MODE control (Jj) is set to
A D D .
7 CH2 INVERT
The inverted polarity of C H 2 " J " is displayed by con-
trolling the • POSITION/PULL INV (jjj) .
8 Sweep Scale Factor
Displays the s w e e p range set by the S W E E P T I M E / D I V .
When the S W E E P V A R I A B L E is not in C A L mode, a " > "
is displayed. W h e n T R I G G E R I N G MODE is set to X - Y ,
this display is changed to " X - Y " .
13