Table of Contents
Advertisement
S w e e p Magnification
Linearity
HOLD O F F
T R I G G E R I N G
Internal S y n c
CH1
C H 2
LINE
External S y n c
E X T
External S y n c Input Impedance
ft\ Max. External Trigger Voltage
Coupling
S y n c sensitivity
A t NORM position
A C
HFrej
T V
(AUTO)
C A L I B R A T I O N V O L T A G E
I N T E N S I T Y M O D U L A T I O N
Sensitivity
Input Impedance
Usable Frequency Range
A
Maximum Input Voltage
R E A D O U T
Calendar
Set value
4 V 1 :
Cursor mode:
AV2:
AT:
MAI:
NOTE: T h e X - Y mode allows AS/I measurement only.
Cursor
Resolution
measurement
Measurement
accuracy
Measurable range
± 3 % ( x 10 M A G , 0 . 2 / i S ~ 1 0 jis, ± 5 % )
Adjustable by the controller
Triggered by signal applied to E X T T R I G INPUT jack
Approx. 1 MG, approx. 3 2 pF
A C , HFrej, T V F R A M E , T V LINE
S y n c frequency range : 10 Hz - 5 0 MHz
S y n c frequency rage : 1 0 Hz ~ 1 0 0 MHz
INT : 1.5 div, E X T : 0 . 2 Vp-p
The sync frequency range is more than 1 0 kHz, and the minumum amplitude
(Voltage) required for sync is increased.
INT : 1.5 div, E X T : 0 . 1 5 Vp-p
Rating shown above is provided at 5 0 Hz or over.
1 V ± 3 % , square w a v e , positive polarity, approx. 1 kHz
+ 5 V , positive voltage decreases brightness.
Year/Month/Day/O'clock/Minute
Clock accuracy : ± 2 min./month
Battery life : About 2 0 , 0 0 0 hours (at room temperature)
C H 1 / C H 2 scale factor (with probe detection); V - U N C A L , A D D , INVERT
Sweep scale fator (magnification conversion); S W E E P V A R I A B L E - U N C A L , X - Y
Voltage difference between AREF and A cursors on the basis of CH1 scale factor
Voltage difference between AREF and A cursors on the basis of CH2 scale factor
Time difference between AREF and A cursors on the basis of sweep scale factor
Frequency between AREF and A cursors on the basis of s w e e p scale factor
Ratio: Voltage ratio and time ratio between AREF
5 div. on the C R T as 1 0 0 %
Phase: Phase difference between AREF and A cursors, supposing 5 div. on the
C R T as 3 6 0 °
AV, Ratio: ± 3 . 6 div or more from the C R T center
AT, VAT, Ratio, Phase: ± 4 . 6 div or more from the C R T center
x 10 (ten times) ± 5 %
Triggered by C H 1 signal
Triggered by C H 2 signal
Triggered by line frequency
50 V (DC + A C peak)
INT : 1 div, E X T : 0.1 Vp-p
F R A M E , LINE
Approx. 10 kO
DC to 2 MHz
50 V (DC + A C peak)
1 0 bits
± 4 %
and A cursors, supposing
5
Advertisement
Table of Contents
