Install The Motherboard - ECS 661GX-M2 V5 Manual

Install the Motherboard

Install the motherboard in a system chassis (case). The board is a Micro ATX
size motherboard. You can install this motherboard in an ATX case. Make sure
your case has an I/O cover plate matching the ports on this motherboard.
Install the motherboard in a case. Follow the case manufacturer's instructions to
use the hardware and internal mounting points on the chassis.
ATX1
Connect the power connector from the power supply to the ATXPW1 connector
on the motherboard. The ATX1 is a +12V connector for CPU Vcore power.
If there is a cooling fan installed in the system chassis, connect the cable from the
cooling fan to the CHSFAN fan power connector on the motherboard.
Connect the case switches and indicator LEDs to the SW1 header. Here is a list
of the SW1 pin assignments.
Pin
1 HD_LED_P(+)
3 HD_LED_N(-)
5 RESET_SW_N(-)
7 RESET_SW_P(+)
9 RSVD_DNU
Chapter 2: Motherboard Installation
1
CHSFAN
Signal Pin Signal
2 FP PWR/SLP(+)
4 FP PWR/SLP(-)
6 POWER_SW_P(+)
8 POWER_SW_N(-)
10 KEY
11
ATXPW1
1
SW1