Pci/Plug And Play Setup Page - ECS 661GX-M2 V5 Manual

Motherboard User's Guide
Keyboard Power On
If you enable this item, the system can automatically resume by pressing any
keys, hot key, power key on the keyboard, or typing in the password. You must
use an ATX power supply in order to use this feature.
LAN/Ring Power On
The system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call on the Modem/
Ring, or traffic on the network adapter. You must use an ATX power supply in
order to use this feature.
PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the PCI bus and
those utilizing the system plug and play capability.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
Primary Graphics Adapter
This item indicates if the primary graphics adapter uses the PCI or the AGP bus.
The default PCI setting still lets the onboard display work and allows the use of
a second display card installed in an AGP slot.
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics system.
You set this value to No to free up an IRQ.
PCI IDE BusMaster
This item enables or disables the DMA under DOS mode. We recommend you to
leave this item at the default value.
PCI / Plug and Play Setup
PCI
Yes
Disabled
Select which graphics controller
to use as the primary boot
device.
24
Help Item