Compaq 7000 Series Maintenance And Service Manual page 84

Compaq Presario Internet PC 7000 Series Computers
PRODUCT DESCRIPTION
REMOVAL AND REPLACEMENT PROCEDURES
Replacing the Microprocessor/Heatsink Assembly, continued
ELECTROSTATIC
DISCHARGE
SERVICE
CONSIDERATIONS
PREPARATION FOR
ASSEMBLY
SERIAL NUMBER
SIDE ACCESS PANEL
GRAPHICS CARD
EXPANSION CARD
(Modem or Network
Card)
1394 CARD
MEMORY MODULE
HARD DRIVE
DISK DRIVE
REMOVING THE TOP
DOOR
REMOVING THE CD
STORAGE DOOR
(Lower Front Panel -
Open the CD Storage
Door)
OPTICAL AND MASS
STORAGE DEVICES
JUMPER AND SWITCH INFORMATION
Peel back the plastic tab on the thermal pad carefully, so the new
thermal pad will stick properly to the heatsink surface. If the new
WARNING thermal pad is not applied properly, the microprocessor/ heatsink
assembly will not work properly, and you risk damaging the system
board.
TROUBLESHOOTING
Replacement
Place the new thermal pad (plastic side up) onto the heatsink
3.
in the same position as the old thermal pad.
With the round portion of the screwdriver handle, rub the top
4.
of the new thermal pad to ensure that the entire pad sticks to
the heatsink. Remove and discard the plastic tab, leaving the
new thermal pad applied to the heatsink.
Next Step
United States
REMOVAL AND REPLACEMENT PROCEDURES
ILLUSTRATED PARTS CATALOG
SPECIFICATIONS