Compaq 7000 Series Maintenance And Service Manual page 32

Compaq Presario Internet PC 7000 Series Computers
PRODUCT DESCRIPTION
REMOVAL AND REPLACEMENT PROCEDURES
Service Considerations
ELECTROSTATIC
DISCHARGE
Tool Requirements
SERVICE
CONSIDERATIONS
PREPARATION FOR
ASSEMBLY
SERIAL NUMBER
SIDE ACCESS PANEL
Screws
GRAPHICS CARD
The screws used in these products are not interchangeable. If an incorrect screw is used
EXPANSION CARD
(Modem or Network during the reassembly process, it could cause damage to the unit. Compaq strongly
Card)
recommends that all screws removed during the disassembly process be kept when a
component is removed, then returned to their proper locations when the component or its
1394 CARD
replacement is installed.
MEMORY MODULE
IMPORTANT
HARD DRIVE
DISK DRIVE
REMOVING THE TOP
DOOR
Cables and Connectors
REMOVING THE CD
STORAGE DOOR
Most cables used throughout the unit are ribbon cables. These must be handled carefully
(Lower Front Panel -
to avoid damage. Apply only the tension required to seat or unseat the cable during its
Open the CD Storage
insertion or removal from the connector. Handle cables by the connector whenever
Door)
possible. In all cases, avoid bending, twisting, or tearing the cables, and ensure that they
OPTICAL AND MASS
are positioned so they cannot be caught or snagged by parts being removed.
STORAGE DEVICES
(CD, CD-RW and/or
JUMPER AND SWITCH INFORMATION
Phillips screwdriver
1.
Needle-nose pliers
2.
Flathead screwdriver
3.
Compaq Utilities software
4.
As each subassembly is removed from the computer, it should be placed
away from the work area to prevent damage.
TROUBLESHOOTING
United States
REMOVAL AND REPLACEMENT PROCEDURES
ILLUSTRATED PARTS CATALOG
SPECIFICATIONS