Cardin S504 Manual page 21

3. Deleting a channel code
- Move the transmitter near to the interface.
- Press and hold down the P2 button on the interface, the Led L1 will flash quickly and the buzzer will beep twice.
- Press the button (channel) you wish to cancel on the transmitter.
- The Led L1 on the interface will glow continuously and the buzzer will beep twice. After a few moments led L1 will switch off.
- Release the P2 button. End of operation.
Note: if no codes are present in memory the interface will beep ten times.
4. Memorizing more transmitters by using a previously memorised transmitter
This procedure allows you to enable a new transmitter (from a remote position) with the help of a transmitter that has already been memorised in the system. As the
presence of the interface is not required this procedure can be carried out in any remote location (for example in your chosen sales outlet).
Access to the "rapid memorizing" procedure can be enabled or disabled on the receiver by inserting (or removing) the jumper J1:
• Jumper J1 when inserted the rapid memorization procedure is enabled.
• Jumper J1 when not inserted the rapid memorization procedure is disabled
- Remove the upper cover from the transmitter to be memorised and from the transmitter that has
already been memorised as shown in the drawing below (det. a).
- Place the transmitter A, that has already been memorised in the interface, beside the new transmitter
B (det. b).
- Using a pointed object press and release the MR button on both transmitter (in sequence or
simultaneously).
- The orange LEDS on the transmitters will flash slowly.
- Press and release a channel button on transmitter A that is already present in the interface (det. c).
- The led of the new unit B will remain lit for 3 seconds to confirm memorization (det. d).
Transmitter B will now command the interface exactly like transmitter A.
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
21
All rights reserved. Unauthorised copying or use of the information contained
1
MR
3
A
2
A
MR
B
B