Watts Lync DigiTemp Jr V23 User Manual/Instruction Manual page 8

Set up and Programming
Create a passcode
DigiTemp Jr. comes programmed with a factory default passcode (1017). For added security, and to help
®
prevent unauthorized access, it is recommended that you create a unique 4 digit passcode as outlined
below.
1. On the Programming Menu, touch the UNLOCK icon. The Unlock function screen will appear and you will
be prompted to enter the passcode:
2. Creating your own passcode:
• To create your own passcode, enter the factory default passcode 1017 and press the Help icon in the
lower right corner of the Unlock screen.
• Enter a new 4-digit passcode and touch the Enter icon (make sure to keep your new code in a secure
place).
• Re-enter the new passcode and touch the Enter icon again to finalize the passcode change.
NOTICE
If you make a mistake when re-entering your new passcode and it does not match your first entry, ????
will appear.
10
Set up and Programming
Unlock the system
1. To unlock the system, on the Unlock screen, enter your new passcode, and touch the Enter icon.
NOTICE
If you need to clear your entry and start again, touch the CLEAR icon. If you want to go back to
Programming Menu, touch the BACK icon.
If you did not set up your own passcode, you can enter the factory default passcode 1017.
2. When the passcode is entered, you will be directed to the liability and responsibility acceptance screen:
3. You must touch the ACCEPT icon to proceed to the Programming Menu and to use system functions.
Touching the DECLINE icon means you will not be able to change system settings and you accept all default
settings (including the outlet water temperature set point of 140°F/160°C) as safe and appropriate
for the water distribution system users and the facility. You will be returned to the "Programming" screen.
4. When you touch the ACCEPT icon, you will access the Programming Menu, which will appear as:
11