C) Weather Station; Operation; A) Setting The Date & Time - Renkforce 2377869 Operating Instructions Manual

c) Weather station

Install the table stand
1
1. Fasten the table stand to the weather station. See figures on
the right side.
2. Place the weather station on a level, stable surface.
You may also hang the weather station on a wall using
a screw.
Connect the power adapter
2
• Connect the adaptor plug with the power supply connector on the weather station.
• Connect the power adapter to a common household mains socket.
To help reduce signal interference, place the weather station at least 1 m away from the power adapter.
Pairing
3
After the batteries have been inserted and the power adapter is connected, the weather station will automatically
search for the outdoor sensor signal. After the units pair successfully, the measured data from the outdoor sensor will
be displayed on the weather station.
If you have changed the batteries of the outdoor sensor, you must initiate pairing manually. Proceed as follows:
1. Replace batteries.
2. Press the SENSOR button on the weather station.
3. Press the RESET button on the outdoor sensor. This will generate a new code for pairing purpose.

11. Operation

a) Setting the date & time
1 Date
2 Time
3 RCC signal strength indicator
4 DST
5 Alarm
6 Moon phase
7 Day of the week
Step 1
2 3 5
4
Step 2
6 7
47