J) Wireless Signal Reception; K) Display Brightness (Backlight) - Renkforce 2377869 Operating Instructions Manual

3. Once you have selected the section, press the
• When Indoor symbol appears, the selection sequence is: In Temperature HI → In Temperature LO → In
Humidity HI → In Humidity LO → Baro Pressure.
• When Outdoor symbol appears, the selection sequence is: Out Temperature HI → Out Temperature LO →
Out Humidity HI → Out Humidity LO → Wind HI → Rain rate HI.
• When CH1, 2 or 3 symbol appears, the selection sequence is: CH Temperature HI → CH Temperature LO
→ CH Humidity HI → CH Humidity LO.
4. In the alert type, the selected value will flash, then press the
buttons to adjust the value. Press and hold the button for quick adjust-
ment.
5. Press the button (Alert) to toggle the alert on / off. The alert indica-
tor shows on the display when the alert is On.
6. Press the button (Alert) to confirm and move to the next setting.
7. When you complete the setting, press and hold the
for 2 seconds to exit alert setting.
If no button is pressed, the unit will automatically exit setting mode after 60 seconds.
When Alert alarm sounds, the area and type of alarm that triggered the alarm will be flashing and the alarm
will sound for 2 minutes.
To silence the Alert alarm, press the SNOOZE or the
off after 2 minutes.

j) Wireless signal reception

The operating range of the outdoor sensor is 150 m in an open space. If the weather station does not receive a signal,
choose a different location for the weather station or the outdoor sensor.
The quality of radio reception is indicated by an icon in the top left corner (OUTDOOR) of the display.
No sensor
Signal strength indicators for the CH 1-3 optional thermo-hygro sensor are the same as above.

k) Display brightness (backlight)

You can adjust the display brightness of main unit, using the OFF / LO / HI slide switch:
- HI position: Bright backlight.
- LO position: Dimmed backlight.
- OFF position: Turn off the backlight.
Signal searching Strong signal
button (Alert) to select the alert type:
or
button (Alert)
button (Alarm), or let the alarm automatically turn
Weak signal Signal lost
57