Table of Contents
Advertisement
User's Guide
E-6
Message:
MAC address of your printer may be filtered. Check whether your router/access point has restrictions such as
MAC address filtering. See the documentation of the router/access point or contact your network administrator for
assistance.
Solutions:
❏ Check if MAC address filtering is disabled. If it is enabled, register the printer's MAC address so that it is not
filtered. See the documentation provided with the access point for details. You can check the printer's MAC
address from the Network Status part on the network connection report.
❏ If your access point is using shared authentication with WEP security, make sure the authentication key and
index are correct.
❏ If the number of connectable devices on the access point is less than the number of network devices that you
want to connect, make settings on the access point to increase the number of connectable devices. See the
documentation provided with the access point to make settings.
Related Information
"Setting Items for Advanced Network Settings" on page 29
&
"Printing a Network Status Sheet" on page 38
&
E-8
Message:
Incorrect IP address is assigned to the printer. Confirm IP address setup of the network device (hub, router, or
access point). Contact your network administrator for assistance.
Solutions:
❏ Enable DHCP on the access point if the printer's Obtain IP Address setting is set to Auto.
❏ If the printer's Obtain IP Address setting is set to Manual, the IP address you manually set is invalid due to out
of range (for example: 0.0.0.0). Set a valid IP address from the printer's control panel or by using Web Config.
Related Information
"Setting Items for Advanced Network Settings" on page 29
&
E-9
Message:
Confirm the connection and network setup of the PC or other device. Connection using the EpsonNet Setup is
available. Contact your network administrator for assistance.
Solutions:
Check the following.
Network Settings
35
Advertisement
Table of Contents
