Table of Contents
Advertisement
10/84
Safety instructions
General
During transport
During assembly
During commissioning
During operation
Bosch Rexroth AG, MIT: HQ 2/G-H, BS 2/G-250, 3 842 564 989/2022-06
• Use only original accessories and spare parts from Rexroth in order to prevent
hazards to people due to unsuitable spare parts.
• Observe the technical data and ambient conditions specified in the product
documentation.
• Only start up the product if it has been determined that the end product
(for example, a machine or system) into which the Rexroth products have been
installed complies with national provisions, safety regulations and application
standards.
2.6 Product-specific safety instructions
• Do not attempt to modify the product.
• Do not expose the product to any mechanical loads under any circumstances.
Never use the product as a handhold or step. Do not place any objects on the
product.
• Always secure the product against tipping over.
• Observe the transport instructions on the packaging.
• Inspect the product for obvious transport damage.
• Lay cables and lines so that they cannot be damaged and no one can trip
over them.
• Make sure the system component you are working on is depressurized and
de-energized before assembling the product or inserting or removing plugs.
• Ensure that the system component cannot be switched back on.
• Before commissioning, make sure that all seals and plugs for the plug connectors
are correctly installed and not damaged to prevent liquids and foreign bodies
from entering the product.
• Allow the product to acclimatize for a few hours prior to commissioning in order
to prevent water condensation from forming in the housing.
• Make sure that all electrical and pneumatic connections are either in use or
covered.
• Check the safety requirements according to DIN EN 619.
• Only commission a product that has been completely installed.
• Make sure that all the safety equipment which forms part of the product is
present, has been properly installed, and is fully functional. Do not move,
bypass or disable any safety equipment.
• Do not reach into moving parts.
• Check the product for malfunctions.
• Make sure that only authorized personnel perform the following tasks within the
scope of the product's intended use:
– Starting or operating the system or interfering with its normal operation.
– Operating component or part adjusters.
• Only allow people to be in the immediate vicinity of the product when it is
operating if they are authorized by the owner to be there. This also applies when
the product is idle.
• Make sure that:
– There are no obstacles preventing access to the EMERGENCY STOP controls.
– All delivery points, workstations and passages are kept clear.
Advertisement
Table of Contents
