Hammer (Option) - Volvo EC35 Operator's Manual

1
1
2
2
1016534
A
B
1016538
D
C
1016542

Hammer (option)

The hammer is mainly used in road construction, in demolishing
work and work with rock material. Different hammer chisels are av-
ailable to suit a vast variety of applications.
WARNING!
Safety regulations, operating instructions and maintenance
instructions issued by the hammer manufacturer must be
strictly observed!
1016543
Attachment and removal of hammer
Attachment and removal of hammer with manual
fastening
Attaching the hammer
1 Place the machine on firm and level ground. Position the mach-
ine as required for the hammer laying flat on the ground.
2 Slowly lower and align the boom, until the fastening bores of
the hammer are flush with the holes in the boom.
3 Insert bolts (1) into the fastening bores (2).
WARNING!
Before removing or connecting hydraulic hoses the engine
must be shut down and the control levers shifted to all
directions, in order to relieve any trapped pressure. It must
be strictly assured that the engine cannot be started after
hydraulic couplings have been opened.
4 Clean the hydraulic connections on hammer and boom.
IMPORTANT! Protect the hydraulic connections against dirt,
because only this will ensure the correct function of hydrau-
lic connections and hydraulic system.
5 Connect the hydraulic hoses of the hammer to the hydraulic
connections (return line (A) and pressure line (B)) on the boom
by sliding the hydraulic coupling (C) accordingly. Then lock the
hydraulic coupling (C) by turning the black safety rings (D).
IMPORTANT! Ensure correct engagement of the hydraulic
connections.
NOTE! Depending on the equipment the hydraulic connec-
tions on the boom can vary from the illustration and the des-
cription.
Operating techniques
Hammer (option) 61