Table of Contents
Advertisement
QUICK START GUIDE
Integrated Panel Installation
1.
Fully open door.
2.
Starting at corner, pull
gasket away from door.
3.
Continue to pull gasket free
from gasket channel.
4.
Upon removal, lay gasket down on a flat surface.
If the unit has front-mounted hinges, skip ahead
to Step 9.
5.
Partially loosen the 3 screws securing the top hinge to
the top of the cabinet.
6.
Align the panel with the outside edge (opposite the
hinge) and high enough to align with the highest point
in the door.
7.
Insert panel underneath top hinge and apply upward
pressure while bringing the lower portion of the panel
flush to the door inside the lower hinge; the panel will
fit snuggly.
8.
Align door with cabinet. Tighten the top 3 screws,
securing the top hinge to the cabinet.
NOTICE
NOTICE
Due to differences in floor construction or
Due to differences in floor construction or
surrounding cabinetry, the panel may not sit
surrounding cabinetry, the panel may not sit flush
flush with the top of the door/drawer.
with the top of the door.
9. Secure integrated
panel to door/drawer
using clamps. A
robust tape may also
be used. U-Line
recommends the use
of bar clamps to
u-line.com
Door
Panel
Bar
Clamp
Door/Drawer
9.
With panel aligned
to the door, secure
panel to door using
clamps. A robust tape
may also be used.
U-Line recommends
the use of bar clamps
to secure the panel
to the door. If using
tape, be certain the
tape will not damage
panel finish upon
removal.
10. Using a 7/64" (3 mm)
drill bit, drill 6 pilot
holes into the wood
panel 1/2" (12 mm)
deep using the holes
in the door frame as
a guide.
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid splits
in the wood when hardwood is installed.
11. Locate 6 of the #6x 1-1/2" (38 mm) screws provided
with your unit.
12. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over-
tighten screws.
13. Ensure the screws sit flush against the bottom of the
channel.
Integrated Panel
14. Remove clamps from door.
NOTICE
If panel requires additional adjustment after
removing clamps, slightly loosen each screw and
adjust panel as necessary. Tighten screws upon
completion.
15. Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated.
20
u-line.com
Bar
Clamp
Door/Drawer
Wood
Panel
Bar
Clamp
Integrated Panel
Advertisement
Table of Contents
