Table of Contents
Advertisement
USER GUIDE
QUICK START GUIDE
NOTICE
The drain pan was not designed to capture the
water created when manually defrosting. To
prevent water from overflowing the drain pan
and possibly damaging water sensitive flooring,
the unit must be removed from cabinetry.
To defrost:
1. Disconnect power to the unit.
Integrated Models
2. Remove all products from the interior.
To clean integrated panels, use household cleaner per the
3. Prop the door in an open position (2 in. [50 mm]
cabinet manufacturer's recommendations.
minimum).
INTERIOR CLEANING
4. Allow the frost to melt naturally.
Disconnect power to the unit.
5. After the frost melts completely clean the interior and
Clean the interior and all removed components using a mild
all removed components. (See INTERIOR CLEANING).
nonabrasive detergent and warm solution applied with a
soft sponge or non-abrasive cloth.
6. When the interior is dry, reconnect power and turn unit
Rinse the interior using a soft sponge and clean water.
on.
Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transfer taste
and/or odor to the interior products and damage or discolor
NUGGET ICE MACHINE
the interior.
NUGGET ICE MACHINE CLEANING CYCLE
This ice machine has an automatic clean alert function.
CL
The control will indicate
CL
to clean your unit. When
will continue. Depending on water conditions, more
frequent cleaning may be necessary: see chart below.
Cleaning removes lime scale, other mineral deposits, and
sanitizes the machine. Poor ice quality and reduced ice
output are signs that cleaning is necessary.
TDS (Total Dissolved Solids)
Level mg/L (ppm)
5 - 150
150 - 250
250 - 400
Hardness Level mg/L (ppm)
0 - 66
67 - 133
134 - 200
Cleaning
u-line.com
in the display, reminding you
is displayed, ice production
Cleaning Interval
6 months
4 months
3 months (or sooner)
Cleaning Interval
6 months
4 months
3 months (or sooner)
USER GUIDE
Under normal conditions cleaning should be done
when the display shows
cleaning cycle at any time by pressing and holding
the clean button for 10 seconds.
in the display indicating the start of the cleaning
process.
Failure to clean may reduce the quality and quantity of ice
produced. Once the clean cycle begins, it can be canceled
by pressing
three times. Press
making ice. The clean cycle will automatically cancel if user
fails to activate control at steps 2, 3b, and 5b within 2 hours.
Required for cleaning:
•
Clean potable water
•
Bucket and cleaning sponge
•
Internal water filter (if applicable) —
ULANUGGETFILTER**
•
SafeCLEAN Plus™ Cleaner — ULANUGGETCLEAN**
•
Hose (7⁄16" ID x 9⁄16" OD) and funnel
◦
Register your product at u-line.com and receive
a free cleaning kit - ULANUGGETCLEANKIT**
(cleaner, hose, & funnel)
** available for purchase at u-line.com or your local dealer
Need more cleaner? Visit u-line.com
CAUTION
!
Use only SafeCLEAN Plus™ Cleaner. Use of any
other cleaner may damage the finish of the
evaporator and will void the warranty.
Follow safety and handling instructions printed on
the SafeCLEAN Plus™ bottle.
Notice:
Select models include a water filter. The filter
must remain in place when using and cleaning
the machine. The filter is designed to filter out
scale, sediment, particles and cloudiness as well
as reduce chlorine and other off tastes and odors.
U-Line recommends replacing the filter (Part No.
ULANUGGETFILTER) when you clean your machine.
The filter is available at u-line.com.
31
Cleaning
u-line.com
u-line.com
CL
. You may initiate a
0 1
will appear
once more to start
Advertisement
Table of Contents
