Solving Hardware Installation Problems - HP Compaq dx6050 MT Reference Manual

Troubleshooting Without Diagnostics

Solving Hardware Installation Problems

You may need to reconfigure the computer when you add or remove hardware, such as an
additional diskette drive. If you install a plug and play device, Windows 2000 and Windows XP
automatically recognize the device and configure the computer. If you install a non–plug and
play device, you must reconfigure the computer after completing installation of the new
hardware. In Windows 2000, select the Add New Hardware icon in the Control Panel (for
Windows XP, use the Add Hardware Wizard) and follow the instructions that appear on the
screen.
Solving Hardware Installation Problems
Problem
A new device is not
recognized as part of
the system.
Computer will not start.
D–16
Cause
Device is not seated or
connected properly.
Cable(s) of new
external device are
loose or power cables
are unplugged.
Power switch of new
external device is not
turned on.
When the system
advised you of changes
to the configuration, you
did not accept them.
A plug and play board
may not automatically
configure when
added if the default
configuration conflicts
with other devices.
Wrong memory
modules were used in
the upgrade or memory
modules were installed
in the wrong location.
319865-008
Solution
Ensure that the device is properly
and securely connected and that
pins in the connector are not
bent down.
Ensure that all cables are properly
and securely connected and that
pins in the cable or connector are
not bent down.
Turn off the computer, turn on the
external device, then turn on the
computer to integrate the device
with the computer system.
Reboot the computer and follow the
instructions for accepting the
changes.
Use Windows 2000 or Windows XP
Device Manager to deselect the
automatic settings for the board and
choose a basic configuration that
does not cause a resource conflict.
You can also use Computer Setup to
reconfigure or disable devices to
resolve the resource conflict.
1. Review the documentation that
came with the system to
determine if you are using the
correct memory modules and to
verify the proper installation.
2. Observe the beeps and LED
lights on the front of the
computer. See Appendix C,
"POST Error Messages,"
determine possible causes.
Service Reference Guide, d300, dx6050
to