HP Compaq dx6050 MT Reference Manual page 163

6. Install the drive by sliding it into the appropriate drive bay on the front of the chassis. The
drivelock automatically secures the drive in the bay.
CAUTION: Make sure the guide screws line up with the guide slots in the drive cage. The use of
Ä
unnecessary force when installing any drive into the drive bay may result in damage to the drive.
7. When installing an optical drive, the default audio solution is digital audio. If analog audio is
preferred, connect the audio cable from the drive to the embedded audio connector on the
system board.
8. Connect the data and power cables on the to the drive.
Refer to Chapter 4, "Serial and Parallel ATA Drive Guidelines and Features,"
attaching the cabling to get optimum performance.
9. Replace the front bezel
10. Replace the computer cover
11. If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and
enable the Smart Cover Sensor.
Service Reference Guide, d300, dx6050
Removal and Replacement Procedures— Desktop (DT) Chassis
(Section 8.6, "Front Bezel").
(Section 8.5, "Computer
319865-008
for information on
Cover").
8–21