Table of Contents
Advertisement
WARNING
1.
When driving the forklift on a slope, keep the forks always facing the uphill direction and
drive in turtle speed mode.
2.
Do not cross or turn around on a slope.
CAUTION
1.
Have a second person as lookout if the visibility of the operator is reduced.
2.
Do not depress the brake pedal with a lot of force, since excessive force might cause
damage to the braking system.
Unloading
1.
Drive the forklift carefully up to the stacking destination and decelerate when
approaching.
2.
Raise the forks to the proper height.
3.
Drive the forks and load into the shelf.
4.
Set the mast in the vertical position and lower the forks to the proper height until they get
separated from the forks (until the forks are clear of the load).
5.
Slowly remove the forks from the bottom of the load. The mast must keep in vertical or
tilted forward position.
6.
After driving the forks out, raise them and start the next.
DANGER
1.
When approaching the load, do not travel at high speed to avoid crashing.
2.
Do not stay beneath the raised load.
WARNING
1.
When transporting the load, the load should be securely fastened on a pallet with the
gravity center well centered and with the proper stacking height. Do not damage the
packing of the load. The operator should be held responsible for the safe loading and
unloading.
2.
If the mast is tilted backwards before the forks enter beneath the loads, the forks might
damage the load or might not enter fully under the load and cause danger.
Note
Pull up the red Emergency Disconnect Switch before switching on the forklift. And then the
forklift is ready for operation.
https://www.forkliftpdfmanuals.com/
67
ECB16 ECB18
OM-ECB162015006-EN-US
Advertisement
Table of Contents
