Table of Contents
Advertisement
Gear Oil
Gear Oil replacement (Dual Drive)
1.
Run the forklift until the gear box gets lightly heated. Park the forklift on a level floor,
apply the hand brake, switch off the forklift, remove the key and press down the
emergency disconnect switch.Lift the forklift with jack and secure the wheels with
wedges.Remove the wheels.
2.
Clean the surrounding areas around the "Oil drain plug", "Oil filler plug" and "Oil dipstick
plug". Place a container below the "Oil drain plug".
3.
Remove "Oil drain plug","Oil filler plug"and "Oil dipstick plug" and drain all the gear oil.
4.
Put the "Oil drain plug" back on and tighten it. (Torque: 4.5ft-lbs)
5.
Add the gear oil through oil filler hole until the gear oil overflows out of "Oil dipstick plug".
6.
Tighten both "Oil dipstick plug" and "Oil filler plug" (Torque: 4.5ft-lbs)
7.
Refit the wheel and replace the gear oil in the gear box on the other side.
(1) Oil filler plug (2) Oil dipstick plug (3)Oil drain plug
CAUTION
1.
Make sure that the gear oil reaches the lower edge of the oil dipstick plug.
2.
Use only Mobifluid 424 gear oil. If you need to use other types of gear oil, contact with
BYD after sales service people.
3.
The working temperature of gear box cannot exceed 248°F.
4.
Every 3000 working hours, check if the piston inside the driving axle exceeds 0.14in. If
yes, contact with BYD after sales service personnel.
https://www.forkliftpdfmanuals.com/
1
2
91
ECB16 ECB18
1
2
3
OM-ECB162015006-EN-US
Advertisement
Table of Contents
